I'M WONDERING IF ANYONE COULD GET THE MEASUREMENTS WHERE THE RADIATOR SUPPORT BRACKETS MOUNT ON A 32 FORD (FIREWALL SIDE) UP FROM THE FRAME AND THE DISTANCE APART LEFT TO RIGHT.

THANKS, JOEL (cdanman) VAN BRUGGEN


you can tune a carb, but you can't tuna fish :-)

I'm the last guy to be giving out dimensions seeing how I'm new to this game, but you didn't get any response on your question so here goes. If you saw a guy walking aroung Columbus or Louisville with a yardstick, tape measure and a note pad in his hand, that was me. One of the measurements that I did get was off of an Outlaw car and it was the distance between the radiator support rods where they fasten to the firewall. It is 26.5". I can't help you out on the distance up from the frame, but if memory serves me right I think the rods are close to being level or an inch or so down from the cowl. Hope this helps. Good luck..

Joel,

I can give you those dimensions. Just give me some time to get my nerve up to go out to the barn this morning.
--
Dick Z

Joel,

The spacing between the two bars at their centerline is 10 1/4 inches. The distance from the top of the frame to the bottom of the bars is 27 inches. I'm going to e-mail a couple pictures I just took which might help. I have an Outlaw Performance body.
--
Dick Z

THANKS MAC, THANKS DICK, FOR THE MEASUREMENTS FROM YOU BOTH, AND THE PHOTOS FROM DICK ARE A GREAT HELP. BEFORE THIS I HAD NO IDEA WHERE TO GO WITH THE SUPPORTS.
MERRY CHRISTMAS,
JOEL