Thats me holding the fender in place. I have the front apart until I finish with the motor and frontend. I took the truck from 13" original rail height to 7.5" in the front. I plan on lowering the rear next. I am planning on using fiberglass fenders, had to hold up old fenders for visual.

Sorry, trying this again.

This may show a better view of the clearance.

Are you doing a tilt nose on it?
Why glass fenders?

Then I hit the wrong button before I was done!!! Looks good so far:) How did you end up lowering the front?

I am keeping the truck as original looking as I can. The heidts crossmember lowered it some and then I took alittle out of the springs.

Great job. Photos add a nice touch to progress reports of projects. Thanks for sharing. :)
--
Your "top-less" cruzn buddy, Denise

www.loboys.com