I purchased the steering joints today for my chevy. The rep from Flaming River was very helpful in telling me what I needed to complete the set up. I explained that I was using the Fatman Mustang II setup. He set me up with the spline hookup that should work. Got home and the sppline end diameter was off. So question is: How do I figuer up what I need for my Power rack? I tried counting the splines but am not sure if the count is accuruate. I purchased them from Southern Rods and hope that the will swap it out In the morning. But I Need to know if anyone knows the correct size needed or how to figuer it??? The bigger problem is not knowing what power ravck is under the front?

Kelly
--
SORRY----I only get one thought a DAY!!!

Kelly--In Evansville, IN

Kelly, Ford power racks are 3/4" 36 spline.
Wayne
--
Measure twice; cut once, ie. "I cut it three times and it's still too short"

Thanks for the info Wayne!
Kelly
--
SORRY----I only get one thought a DAY!!!

Kelly--In Evansville, IN

Kelly,,if you have a speedway catalog they list all the shapes and sizes by there joints,they have quality stuff and there prices on them are hard to beat too,,,,jim
--
http://community.webshots.com/user/jimcaf12

Jim,

Thanks for the info. The one Wayne said was the correct one. It
s about what I thought to begin with but just needed to make sure I was on the right track. I also wanted to mention that the guys at Southern Rods were great to work with on swapping out the right joint. I explained the problem and they had no problem with the exchange. They were running a great show special that I couldn't pass up!

Thanks again for the help.
Kelly
--
SORRY----I only get one thought a DAY!!!

Kelly--In Evansville, IN