bob's 23 ford roadster

Owner
Divco13

Description
Built this about 12 year ago, you may have seen it in Rod Action Mag Nov/1993. Every thing on the car except, the out side skin of the bucket, was hand made in my in my garage. The hood and the rear trunk was clay modeled, and cast out back too. The frame is 2x4x083 tubing, pinched down front and back. It's got a chy 8 3/4 housing with a 4 bar with watts linkage. Headers were made from a sprint car header kit. The header go Thu and around the front suspension. The head light are off a Suzuki cafe racer 5 inch dia, hand made the bucket's. I swap back and forth between a DZ302 and a 383 stroker with TPI.
When i was done with this one, I built a Divco Milk Truck with a 502/502. it's in the truck section

This is my ride, and I'd like to edit it.